Developer Submits Another Application for Site Not in Neighbourhood Plan
Westbourne Homes who have recently built 11 luxury homes at Charleston Place off the Reading Road in Shiplake have submitted a planning application to build 16 further dwellings behind the development on a green field site to the rear of Pennyhill, Woodlands Road.
The original homes built on ‘Crossways’ was granted planning permission after an appeal against SODC’s decision to refuse it as SODC could not provide evidence in time to show their five-year land supply in October 2022.
The 16 new homes would be accessed via the rear of Charleston Place. Neither development sites were included in the Joint Henley & Harpsden Neighbourhood Plan 2022 (JHHNP).
The site is next to the Thames Farm site where no building has commenced due to problems with the stabilisation of the ground, the safety of the nearby drinking water aquifer and an acceptable system for surface water drainage.
The application came before a recent Town Council’s Planning Committee who recommended it should be refused on the following grounds – Not an approved site in the JHHNP or the South Oxfordshire Local Plan. Matters in the pre-application advice were not addressed in this application. The Committee continues to have significant concerns regarding the insufficient understanding of the ground conditions, specifically the hydrological and geotechnical aspects. The treatment of drainage and the risk of pollution to groundwater in the most vulnerable source protection zone are not sufficient to improve water quality prior to discharge and consequential effects on the underground aquifer. Concerns that the adjacent Thames Farm site applications may also extend to this application site, compounding the potential for negative environmental impact of the proposed development.”
Both Harpsden and Shiplake Parish Councils have also objected to this application citing the same reasons.
If you would like to comment on this application go to https://data.southoxon.gov.uk/ccm





Leave a Comment
Want to join the discussion?Feel free to contribute!